Friedrich EQ08 Air Conditioner User Manual


 
6
920-197-01
Care and maintenance
To remove filter
Simply turn the unit off and pull the filter frame up and towards you (See
Figure 6). Clean with warm water and a mild detergent, rinse, dry, and
replace by sliding the filter back into position behind the front panel.
Figure 6
READ THIS FIRST! Electrical Requirements
IMPORTANT: Before you beginthe actual installation ofthe air conditioner,
be sure your electrical requirements are as described below. Consult an
electrical professional as necessary to insure home wiring is per local
electrical codes.
CIRCUIT PROTECTION - An overloaded circuit will invariably cause mal-
function or failure of an air conditioner, therefore, it is necessary that the
electrical protection is adequate. All portable chassis models require a 15
amp fuse or circuit breaker for over-amperage protection. Due to momen-
tary high current demand when your air conditioner is started, use a "TIME
DELAY" fuse or a HACR type circuit breaker. Consult your dealer or power
company if in doubt.
Yourair conditioner mustbe connected to apowersupply with thesame A.C.
voltage and hertz as marked on the unit nameplate. Only alternating current
(A.C.), no direct current (D.C.), can be used.
The power cord has a plug with a grounding prong of approved type and a
matching plug receptacle with ground is required. Refer to page 3 for the
correct type of plug receptacle for your model.
WARNING: NEVER CUT OR REMOVE THE GROUNDING PRONG
FROMPLUG.NEVERUSEEXTENSIONCORDSTOOPERATEANAIR
CONDITIONER.
Items required for installation (providedinstraightcoolingunitsonly)
ITEM NO. DESCRIPTION QTY.
1
2
3
4
SCREW, SHEET METAL, #8 x
"
SCREW, PHILLIPS, TRUSS HEAD, #8 x ½"
SCREW, HEX, #8 x "
SCREW, PHILLIPS, #8 x 1 ¼"
8
4
10
2
5
6
GRAY GASKET, FOAM, 1" x 1 ½" x 42"
WHITE GASKET, FOAM, 1" x 1 ½" x 48"
1
1
Installation instructions
NOTE: This section includes installation instructions for window mount and thru-the-wallmount methods. TwinTemp
®
heat/cool units are designed forpermanent
thru-the-wall installation. Mounting the unit in a window will require a window mounting accessory kit, available through your Friedrich dealer.
ITEM NO. DESCRIPTION QTY.
7
8
LEFT SIDE CURTAIN ASSEMBLY
RIGHT SIDE CURTAIN ASSEMBLY
1
1
9
10
11
DECORATIVE FRONT PANEL
CABINET OR SLEEVE
AIR CONDITIONING UNIT
1
1
1
ITEM 1 ITEM 2 ITEM 3 ITEM 4 ITEM 5 ITEM 6
ITEM 7 ITEM 8 ITEM 9 ITEM 10 ITEM 11
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner’s
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
WARNING