Friedrich 9315345288 Air Conditioner User Manual


 
En-4
NAME OF PARTS
Fig. 6 Remote Controller
b1 Signal Transmitter
b2 MODE button
b3 MIN.HEAT button
b4 ECONOMY button
b5 SLEEP button
b6 TIMER MODE button
b7 FAN button
b8 START/STOP button
b9 SET button (Vertical)
b10 SET button (Horizontal)
b11 SWING button
b12 SET TEMP. button (
/
)
b13 TIMER SET ( / ) button
b14 CLOCK ADJUST button
b15 TEST RUN button
This button is used when installing the air
conditioner, and should not be used under
normal conditions, as it will cause the indoor
unit’s thermostat function to operate incor-
rectly.
If this button is pressed during normal op-
eration, the indoor unit will switch to test op-
eration mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to fl ash simultaneously.
To stop the test operation mode, press the
START/STOP button to stop the air
condi-
tioner.
b16 RESET button
c1 Remote Controller Display(Fig.7)
c2 Temperature SET Display
c3 Operation Mode Display
c4 SLEEP TIMER Display
c5 Transmit Indicator
c6 Fan Speed Display
c7 SWING Display
c8 Timer Mode Display
c9 Clock Display
Fig. 1 Indoor Unit
a1 Operating Control Panel (Fig. 2)
a2 MANUAL AUTO button
When kept on pressing the MANUAL AUTO
button for more than 10 seconds, the forced
cooling operation will start.
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's use.
When the forced cooling operation starts by
any chance, press the START/STOP button
to stop the operation.
a3 Indicator (Fig. 3)
a4 Remote Control Signal Receiver
a5 OPERATION Indicator Lamp (green)
a6 TIMER Indicator Lamp (orange)
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a fault
has occurred with the timer setting (See
Page 15 Auto Restart).
a7 ECONOMY Indicator Lamp (green)
a8 INTAKE GRILLE (Fig.4)
a9 Front Panel
a10 Air Filter
a11 Airfl ow Direction Louver
a12 Power Diffuser
a13 Right-Left Louver
(behind Airfl ow Direction Louver)
a14 Drain Hose
Fig. 5 Outdoor Unit
a15 Intake Port
a16 Outlet Port
a17 Pipe Unit
a18 Drain port (bottom)