Filter
Top Products
15
MAINTENANCE AND CLEANING (contd.)
Cleaning Cabinet Exterior
WARNING: ELECTRICAL SHOCK HAZARD:
• Never operate or (un)plug unit with wet hands.
• Turn off unit and unplug from wall outlet before cleaning.
• Never submerse the unit in any type of liquid or expose to heavy moisture.
• Never spray, pour, or sponge water directly onto the unit .
• Never use brushes, brooms, harsh detergents, chemicals, solvents, gasoline, or
any other abrasive materials or household items to clean the unit.
• Remove excess moisture from cabinet and grill areas, and make sure indoor
unit and filter are completely dry before installation/operation.
1. Press Power On/Off "I/O" button to stop unit if it is operating. Unplug
power cord from outlet.
2. Wipe cabinet exterior with a soft cloth dampened with warm water
(not to exceed 100Þ) and a mild detergent. Use a dry cloth to
completely dry cabinet exterior.
3. Remove loose debris and lint from air intake grills by using a soft
brush vacuum attachment.
STORAGE
INDOOR UNIT
1. Press power on/off "I/O" button if unit is operating. Unplug
power cord from outlet.
2. Drain water tube. See "Draining Water Tank" on page 13
for detailed instructions.
3. For long-term storage, turn the unit on to "FAN" mode and
allow the unit to run for 3-4 hours. This will dry the inside of the unit.
4. Carefully wrap power cord and secure with cord wrap on back of unit.
5. Store unit in its UPRIGHT POSITION in a cool, dry indoor location. If possible, store
unit in its original box. DO NOT store unit in direct sunlight.
OUTDOOR UNIT
1. Unplug power cord (on indoor unit) from outlet.
2. Carefully remove outdoor unit from mounting brackets and/or hooks.
3. Slowly tilt the outdoor unit to drain water from the drain port.
4. Clean cabinet surface of outdoor unit (see "Cleaning Cabinet Exterior" above).
5. Carefully lift the outdoor unit and align the support plates on the outdoor unit with the
interlocking fasteners on the indoor unit. Carefully hang the outdoor unit onto the
back of the indoor unit.
6. Cover the two connected units with a large, plastic bag.
7. Store two connected units in a cool, dry place. Do not store in direct sunlight.