Filter
Top Products
OPERATION
CAUTION: To avoid damage and voiding your warranty, place both units in their
upright positions for a minimum of two hours before operating. DO NOT operate
unit without air filter properly in place or while tube set is disconnected.
Cooling
This unit is intended to cool a 300-600 square foot area. The unit’s cooling capacity will
vary according to room temperature and humidity. Consult your Freecom dealer for
specific application and suitability.
1. Plug power cord into a standard household outlet. Use this
product only with the proper electrical voltage. See
“SPECIFICATIONS” on page 3.
WARNING: Do not plug this appliance into an outlet that is being used by other
appliances or electrical devices. When installing the electrical plug into the outlet,
never touch or bend the metal prongs and always push plug into outlet by using the
molded plug. Never use the electrical plug to start or stop the unit and avoid pulling,
folding, or stretching the electrical cord.
2. Press Power On/Off ("I/O") button on control panel. The unit will power up
and air will begin blowing from the front louvers.
NOTE: This unit is equipped with a special safety time delay feature.
The compressor (cooling mechanism) may be delayed for up to five
minutes. This safety feature prevents damage to the compressor.
The "COMP. ON" light will turn on while the compressor is running.
3. Press “MODE” button on control panel to choose "AUTO," "HI," "MED,"
"LO," or "FAN." The FAN setting is for air circulation only and does not
provide any cooling. To change from a cooling mode to fan mode, press
power on/off "I/O" button to turn unit off. Press power on/off "I/O" button
again and immediately press "MODE" button to FAN setting. If the air con-
ditioner is re-started, the unit will be in the previously selected mode.
4. Press either "THERMO CONTROL" button to control a
colder or cooler setting. The default temperature is 77ÞF.
Press right button to lower cooling setting; press left button
to raise cooling setting. Each press of the button will adjust
the temperature approximately 1ÞF. The temperature set-
ting can be adjusted from 68ÞF to 86ÞF.
CAUTION: To avoid injury or damage and voiding the warranty,
DO NOT manually adjust the louvers.
5. Press “AUTO SWING” button on control panel to begin oscillating
horizontal louvers. The louvers will move slowly up and down for optimum
air distribution. Press button again to maintain a desired “fixed” position to
distribute more cooling air to one side of the room.
11