Filter
Top Products
OPERATION
CAUTION: To avoid damage and voiding your warranty, place unit in its upright
position for a minimum of two hours before operating. DO NOT operate unit without
condensate water tank and air filters properly in place.
Cooling
This unit is intended to cool a 100-120 s.f. area. The unit’s cooling capacity will vary
according to room temperature and humidity. Consult your Freecom dealer for specific
application and suitability.
1. Plug power cord into a standard household outlet. Use this
product only with the proper electrical voltage. See
“SPECIFICATIONS” on previous page.
WARNING: Do not plug this appliance into an outlet that is being used by other
appliances or electrical devices. When installing the electrical plug into the outlet,
never touch or bend the metal prongs and always push plug into outlet by using the
molded plug. Never use the electrical plug to start or stop the unit and avoid pulling,
folding, or stretching the electrical cord.
2. Press “POWER ON/OFF” button on control panel.The unit will power up
and air will begin blowing from the front louvers.
NOTE: This unit is equipped with a special safety time delay feature.
The compressor (cooling mechanism) may be delayed for up to five
minutes. This safety feature prevents damage to the compressor.
3. Press “AIR VOLUME” button on control panel to choose
between “LO” or “HI.” You may also choose “RHYTHM LO” or
“RHYTHM HI” to allow for a more “gentle breeze” of cooled air.
4. If desired, press “TIMER” button on control panel to program
the air conditioning unit to turn off in either 1, 2, or 3 hours.
CAUTION: To avoid damage and voiding the warranty, DO NOT
manually adjust the vertical louvers.
5. Adjust horizontal louvers (up or down) as desired by moving the
louver handle located at the top, left corner of the horizontal air
louvers. DO NOT adjust horizontal louvers while vertical louvers
are operating.
6. Press “AUTO LOUVER” button on control panel to begin
oscillating vertical louvers. The vertical louvers will move
slowly from left to right and back again for optimum air
distribution. Press button again to maintain a desired
“fixed” position to distribute more cooling air to one side
of the room.
7. To turn unit off manually, press “POWER ON/OFF” button.
Unplug power cord from outlet when not in use.
9