Filter
Top Products
www.fmiproducts.com
120926-26C 9
Figure 10 - Removing Log and Ember
LED
Log
Ember LED
Strip with
Standoffs
REPLACING LOG
1. Follow steps 1 through 4 of Cleaning
Firebox, page 8.
2. Remove screws from each side of log that
secures log to base and remove log (see
Figure 9, page 8).
3. Install new log using screws removed in
step 2.
4. Replace front glass, bracket and screws.
5. Replace trim.
CLEANING AND MAINTENANCE
Continued
REPLACING EMBER STRIP
1. Follow steps 1 and 2 under Replacing Log.
2. Locate ember LED strip (see Figure 10).
Disconnect wire (right side).
3. Remove ember LED strip by squeezing
top of standoffs and discard.
4. Connect new ember LED strip using exist-
ing standoffs.
5. Reconnect wire to LED strip.
6. Follow steps 3 and 4 under Replacing Log.
REPLACING HEATER/BLOWER
1. Follow steps 1 and 2 of Cleaning Firebox,
page 8.
2. Remove screws from around top panel of
rebox (see Figure 11).
3. There are several wires attached to the
top panel. Carefully lift top panel.
4. Disconnect heater/blower wires from main
circuit board.
5. Remove screws holding heater/blower to
top panel (see Figure 11).
6. Remove brackets from heater/blower (see
Figure 12). Save brackets and screws.
7. To remove heater from blower, remove 4
screws (2 per side).
8. If replacing blower, remove screws from
brackets on blower. Install brackets to new
blower.
9. Replace blower or heater. Replace
screws removed in step 7 (see Figure 13,
page 10).
10. Hold heater/blower with brackets in place
against top panel and replace screws
removed in step 5.
11. Reconnect wires to main circuit board (see
Wiring Diagram, page 12).
12. Replace top panel and screws.
13. Replace trim.
Figure 11 - Removing Top Panel and
Heater/Blower
Top Panel
Screws
Screws Securing
Heater/Blower
Figure 12 - Removing Brackets from
Heater/Blower
Brackets