FMI (V)DVF36PS Indoor Fireplace User Manual


 
www.fmiproducts.com
125078-01B 21
FIREPLACE INSTALLATION
Continued
INSTALLING BATTERIES IN
WIRELESS HAND-HELD REMOTE
CONTROL AND RECEIVER
Installing Batteries in Remote Receiver
1. Open bottom access door.
2. Remove switch plate from receiver (see
Figure 31).
3. Remove battery housing cover on remote
receiver to expose battery housing (see
Figure 31).
4. Install 4 AA batteries into housing follow-
ing positive and negative directions on
battery housing cover removed in step 3
(see Figure 31).
5. Replace battery housing cover and switch
plate.
6. Install 2 D batteries into AC backup battery
pack.
7. Close bottom access door.
Figure 29 - Connecting/Disconnecting
Gas Line to Millivolt Valve
Equipment
Shutoff
Valve
Millivolt
Control
Valve
Flexible Gas
Line, Do NOT
Kink
To Gas Supply
(Natural)
To External
Regulator
(Propane/LP)
Figure 30 - Removing/Installing Burner Base
WARNING: Never use an
open ame to check for a leak.
Apply noncorrosive leak de-
tection uid to joints. Bubbles
forming show a leak. Correct
leaks at once.
CAUTION: The gas supply
shall be shut off prior to discon-
necting the electrical power, if
any, before proceeding with this
installation.
CAUTION: Use gloves when
removing the log set/burner
module from your rebox. Some
metal edges may be sharp. Use
caution with log sets as logs
are fragile.
1. Remove glass door (see page 19).
2. Remove grate and all oor media (see
page 20).
3. Carefully lift and remove 3 hearth refrac-
tories from replace.
4. Remove 3 spacers from rebox bottom
(see Figure 30).
5. For 36" models only, remove 3 loose logs
from log set (see Figure 25 page 20).
6. Remove 9 screws from front and sides of
rebox burner base. Lift entire base from
unit by pulling forward to disengage from rear
ange and then lifting up (see Figure 30).
7. If needed, replace burner gasket before
reinstalling log set/burner module (see
replacement parts list on page 36.)
Log
Assembly
Firebox
Bottom
Burner Base
Figure 31 - Installing Receiver Batteries
(Included)
Remote
Receiver
D Batteries
Switch
Plate
Screws
Battery
Housing
Battery
Housing
Cover
AC Backup
Battery Pack
AA
Batteries
Screws
Spacers