Filter
Top Products
TESTING THE SYSTEM
TO BE CONDUCIED WEEKLY
q
Using
the The TFST key puts your system into Test mode, which allows each
s TEST Key protection pofnt to be checked for proper operation.
1. Disarm the system and dose all protected windows, doors, etc. The
NO ALARM REPORTd
ke pad’s
i
nci
READY message should be displayed and the READY
‘cator (if wesent) should be lit.
WILL BE SENT TO THE
I
.
,
cENTRALMoNrroRlNG
2 Enter your security code and press the TEST key.
STATION while the
systemisinTestmode. 1
3. The keypad will sound a single beep every 40 seconds as a reminder
that the system is in the test mode.
Each time a protection zone is faulted, the external siren or bell should
sound for one second and then turn off! while the keypad sounds 3 beeps.
If this does not happen, call for service rmmediately.
4. Open and close each protected door and window in turn and listen for
the required sounds The identification of each faulted protection point
should appear on the display.
5. Walk in front of any interior motion detectors (ff used) and listen for the
required sound as movement is detected. The identification of the
detector should appear on the display when it is activated.
-240