HOW
TO OPERATE YOUR FIRE
EXTINGUISHER IN A FIRE EMERGENCY
TO FIGHT THE FIRE
1. Remove the extinguisher from the mounting bracket.
2. Hold the unit firmly with the nozzle facing away from you. Pull out
the pin to break the “Safety Seal”. You won’t be able to squeeze
the lever until the safety seal is removed.
3. Stand back 6 feet (2 meters) from the fire and make sure the fire is
not between you and your exit.
4. Hold the extinguisher upright and aim the nozzle at the base
of the fire.
5. Squeeze and hold the lever to discharge the powder.
6. Sweep the spray at the base of the bur
ning material, using quick
side-to-side motions. (If the spray scatters the fire, move back.)
7. Move slowly towards the fire as the extinguisher spray pushes the
fir
e back. Maintain a 6-foot (2 meter) distance between you and
the fr
ont of the fir
e at all times.
8. Completely discharge the contents of the extinguisher and make
sur
e the fir
e is completely out. Flashbacks ar
e common with fir
es.
9. For kitchen fires on a kitchen stove, turn off the stove immediately
if possible, otherwise as soon as it is safe.
10. If you suspect a fire had an electrical origin, shut off the electrical
power, if possible, without eliminating your escape route. Do not
touch electrical wires or appliances.
11. After you have completely discharged your extinguisher, leave the
building and close all the doors behind you.
AFTER THE FIRE IS EXTINGUISHED
Do not turn the electrical power back on or plug in any appliances
until the ar
ea has been cleaned up completely
. It is ver
y impor
tant
to remove the powder from electrical equipment after a fire. If the
powder gets wet, it can conduct electricity. (Using a dry chemical
extinguisher on wet electrical equipment may be hazar
dous for this
reason.) This may worsen an electrical leakage problem, impair the
equipment’
s insulation, or cr
eate an electrical shock hazard.
If the fire was on a kitchen stove:
• Make sure the oven and all burners are turned off.
• Clean up the powder completely before using the stove or oven.
See “How to Clean After Using a Fir
e Extinguisher”. V
entilate the
area thoroughly.
If you think the fir
e had an electrical origin:
•
Shut of
f the electrical power
, if possible--do not touch any
electrical wires or appliances.
• Leave the building and close all doors behind you. Call the Fire
Department and have them inspect the premises. As soon as they
say it’
s safe to return, ventilate the area thoroughly.
• Have a licensed electrician inspect your electrical system. Do not
turn the power back on or plug in any electrical equipment until
the inspection has been completed.
•
Make sure your extinguisher may be safely and effectively
used on the small fire you want to fight. Always use extreme
caution when fighting any fir
e. Fight a fire only where there is
a clear escape path to allow you to get out safely if the fir
e
gets worse.
• Avoid breathing smoke and heated fumes; stay low if
necessary. Burning materials will release toxic fumes.
Inhaling these fumes may cause injur
y or death.
•
Always stand back far enough away from the fire—near an
exit—and make sure nothing is between you and your
escape route. If you get too close to a fire, you risk getting
bur
ned or hit by splattering material like grease. If the fire is
too hot or smoky for you to get within 6 feet (2 meters), DO
NOT try to fight the fire yourself. Evacuate immediately and
call the Fir
e Department.
•
For fires on a kitchen stove, turn oven or burners off
immediately if possible. If you can’
t reach the oven or burner
controls safely, extinguish the fire first, then turn them off.
•
Fight the fire from an upwind direction with your back to any
strong air current. Trying to fight a fire with currents blowing
towar
ds you can result in serious injury.
HOW TO CLEAN AFTER USING A FIRE
EXTINGUISHER
NOTE: The powder spray fr
om the extinguisher may spread over a
wide ar
ea, and may soil upholstery, carpets and walls.
•
Sweep/vacuum up as much of the powder as possible. Then use
a damp cloth to wipe of
f the remaining agent.
• If you have any questions about cleaning appliances that the
agent has come into contact with, please contact the appliance
manufactur
er.
IF YOUR EXTINGUISHER NEEDS SERVICE
This fir
e extinguisher is rechargeable by a certified fire equipment
dealer, regardless of how much of the content was used.
Once a year
, a certified fire equipment dealer, in accordance with the
service manual identified on the fir
e extinguisher label, should service
the fire extinguisher. Please refer to your local telephone directory for a
certified dealer
.
Do not tr
y to service or repair this fire extinguisher under any
cir
cumstances. Do not try to remove the nozzle or valve assem-
bly. This is a pressurized device that can cause serious injury if
tamper
ed with.
If ther
e is a problem and it is still under warranty, please see “How to
Obtain Warranty Service” in the Limited Warranty.
DISPOSING OF A USED EXTINGUISHER
If you choose not to have a used extinguisher refilled or a non-working
unit r
epaired, take it outdoors, turn it upside down, and discharge it
completely. Dispose of the empty unit properly, and replace it with a
new fire extinguisher.
Never puncture, burn or expose this fire extinguisher to tempera-
tur
es over 150° F (66° C) even if it is fully discharged. The contents
are under pressure and it could explode.
LIMITED WARRANTY
BRK Brands, Inc. ("BRK") the maker of First Alert
®
brand products,
warrants that for a period of ten years fr
om the date of purchase, this
product will be free from defects in material and workmanship.
BRK, at its option, will repair or replace this product or any component
of the product found to be defective during the warranty period.
Replacement will be made with a new or remanufactured pr
oduct or
component. If the product is no longer available, replacement may be
made with a similar product of equal or greater value. This is your
exclusive warranty.
This warranty is valid for the original retail purchaser from the date of
initial retail purchase and is not transferable. Keep the original sales
receipt. Proof of purchase is required to obtain warranty performance.
BRK dealers, service centers, or retail stores selling BRK products do
not have the right to alter, modify or any way change the terms and
conditions of this warranty.
This warranty does not cover normal wear of parts or damage result-
ing from any of the following: negligent use or misuse of the product,
use on improper voltage or current, use contrary to the operating
instructions, disassembly, repair or alteration by anyone other than
BRK or an authorized service center. Further, the warranty does not
cover acts of God, such as fire, flood, hurricanes and tornadoes.
BRK shall not be liable for any incidental or consequential damages
caused by the breach of any express or implied warranty. Except
to the extent prohibited by applicable law, any implied warranty of
merchantability or fitness for a particular purpose is limited in duration
to the duration of the above warranty. Some states, provinces, or
jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages or limitations on how long an implied warranty
lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have
other rights that vary fr
om state to state, or pr
ovince to pr
ovince.
How to Obtain W
ar
ranty Ser
vice:
Ser
vice:
If service is r
equir
ed, do not return the product to your
retailer. In order to obtain warranty service, contact the Consumer
Affairs Division at 1-800-323-9005, 7:30 AM to 5:00 PM, Central
Standard Time, Monday through Friday. To assist in serving you, please
have the model number and date of purchase available when calling.
Address: 25 Spur Drive, El Paso, TX 79906
Marine Type, U.S.C.G. Type B:C, Size I
U.S.C.G. Approval Number 162.028/EX3622
Valid only with Bracket Number P87-0340
or Bracket Number B70-0161 and Strap Number S70-0007.
Bracket included.
M08-0137-004 M 03/07
First Alert
®
is a registered trademark of the First Alert Trust.
Remove Extinguisher
from Bracket
Break the
Safety Seal
Squeeze and Hold
Lever To Discharge
Powder. Sweep
Side to Side.
OR
2