First Alert FA148CPSIA Home Security System User Manual


 
36
Scheduling (continued)
Scheduling (continued)Scheduling (continued)
Scheduling (continued)
5. For event number “02,” enter the access group
number. Otherwise, this prompt is skipped.
Press [] to continue to the “Start” prompt below.
GROUP NUMBER
X
6. For event numbers “03-07,” enter the partition
number to be armed or disarmed.
0 = arm all; 1 = partition 1; 2 = partition 2;
3 = arm common
Otherwise, this prompt is skipped.
Press [] to continue to the “Start” prompt.
PARTITION
X
7. Enter the event’s start time and days of week.
Hour = 00-12; minute = 00-59
AM = 0; PM = 1
Days = Position the cursor under the desired days
using the [] key to move forward, then press “1” to
select the day.
Press [] to continue.
START SMTWTFS
HH:MMAM 1000000
8. If applicable, enter the event’s stop time and days of
week (applies only to event numbers 01, 02, and 03).
Refer to step 7 for available entries.
Press [] to continue.
STOP SMTWTFS
HH:MMAM 1000000
9. Enter the desired repeat option.
0 = no repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly (every other week)
3 = repeat schedule every third week
4 = repeat schedule every fourth week
e.g., To make a schedule that happens everyday you
would select all days with a repeat count of 1. To
make a schedule that runs for one week then stops,
select everyday with a repeat count of 0.
Press [] to continue.
REPEAT OPTION
0-4 X
10. For event number 01 (output on/off), select the
desired randomize option. 0 = no; 1 = yes
If selected, the schedule times will vary within 60
minutes of the “hour” time. For example, if a
schedule is set to start at 6:15pm, it will do so the
first time 6:15pm arrives, but on subsequent days it
will start anytime between 6:00 and 6:59 p.m.
Press [] to continue.
RANDOMIZE
0=NO 1=YES X