Filter
Top Products
Beep
3
2
1
6
5
4
9
8
7
B
0
A
3
Programming your Personal Code
2
Testing Personal Passcode
Press
reset
button
Closing safe
To lock the safe, press the handle down. If the handle is not
fully closed, the safe will remain unlocked or will not re-open
Ready light ashes
along with a beep
Enter new code: 3-8 digits
followed by the “A” or “B” key.
Ready light ashes along with a beep
SECURITY LOCK-OUT
PERIODS:
For added security, the safe
will automatically “Lock-out”
entry for 15 minutes after
three attempts to open with
an invalid Passcode.
TROUBLE
SHOOTING:
If safe fails to open with
your Personal Passcode,
try the following:
1. Check to see if the
batteries have been
installed properly and
replace if necessary.
2. Lock-out may have
occurred. Wait 15 minutes
before trying again.
3. Contact SISCO / BRK
Consumer Affairs
Department.
Enter new code: 3-8 digits
followed by the “A” or “B” key.
Ready light ashes along with
a beep
Lift the handle within 5 seconds.
The safe automatically relocks in 5
seconds if you take no action
Important:
Important:
If your safe has an interior light, the switch is located inside the safe door.
NOTE: The batteries will run down if you do not turn off the light. The light bulb is
not user replaceable.
Personal Passcode entry
Green light
Hold the handle and
pull the door open