Filter
Top Products
1. Turn off power to smoke alarm at main service panel.
2. Insert a small screwdriver into the slot in the mounting plate. Depress
locking tab with the screwdriver and turn smoke alarm counter-clock-
wise to detach from mounting plate.
3. Gently pull down smoke alarm. Be careful not to separate wire con-
nections.
4. Pull out power plug from back of smoke alarm.
5. From back of smoke alarm, lift tab to open battery pocket door.
6. Remove battery from pocket. Disconnect and discard drained battery
from battery connector.
7. Connect a fresh, 9-volt battery to connector. The battery will fit only
one way. Be sure battery connector is securely attached to battery ter-
minals. Smoke alarm may sound a short beep when battery is
installed. This is normal and means the battery is installed correctly.
8. Place battery into battery pocket.
9. Close battery pocket door. Push down until it snaps into place.
10. Press and hold test button. The alarm will sound if the battery is prop-
erly connected and working.
11. Replace connector plug. Connector will “snap” into place. Gently tug
connector to be sure it is attached properly.
12. Reattach smoke alarm to mounting plate by turning smoke alarm
clockwise until it snaps into place.
13. Turn on power and test smoke alarm using test button.
CLEANING
Clean the smoke alarm at least once a month to remove dust, dirt, or
debris. Always turn off power to smoke alarm before cleaning.
•
Using the soft brush or wand attachment to a vacuum cleaner, vacuum all
sides and cover of smoke alarm. Be sure all the vents are free of debris.
•
If necessary, turn off power and use a damp cloth to clean smoke alarm
cover.
IMPORTANT: Do not attempt to remove the cover or clean inside the smoke
alarm. THIS WILL VOID YOUR GUARANTEE.
REPAIR
CAUTION: Do not attempt to repair this smoke alarm.
Doing so will void your guarantee.
If smoke alarm is not operating properly, see “Troubleshooting”. If neces-
sary and if still under guarantee, return smoke alarm to Sensotec. Pack it
in a well-padded carton and send, postage prepaid to Sensotec address at
the end of this manual.
If the smoke alarm is no longer under guarantee, have a licensed
electrician replace the smoke alarm immediately with a comparable
Firex brand smoke alarm.
PRACTICE FIRE SAFETY
If the smoke alarm sounds its alarm horn, and you have not pushed
the test button, it is warning of a dangerous situation.
Your immediate response is necessary. To prepare for such occur-
rences, develop family escape plans, discuss them with
ALL household members, and practice them regularly.
•
Expose everyone to the sound of a smoke alarm and explain what
the sound means.
•
Determine TWO exits from each room and an escape route to the
outside from each exit.
•
Teach all household members to touch the door and use an alter-
nate exit if the door is hot. INSTRUCT THEM NOT TO OPEN THE
DOOR IF THE DOOR IS HOT.
•
Teach household members to crawl along the floor to stay below
dangerous smoke, fumes, and gases.
•
Determine a safe meeting place for all members outside the building.
WHAT TO DO IN CASE OF A FIRE
1. Don’t panic; stay calm.
2. Leave the building as quickly as possible. Touch doors to feel if
they are hot before opening them. Use an alternate exit if neces-
sary. Crawl along the floor, and DO NOT stop to collect anything.
3. Meet at a pre-arranged meeting place outside the building.
4. Call the fire brigade from OUTSIDE the building.
5. DO NOT GO BACK INSIDE A BURNING BUILDING. Wait for the
fire brigade to arrive.
These guidelines will assist you in the event of a fire. However, to
reduce the chance that fires will start, practice fire safety rules and
prevent hazardous situations.
6
!