Filter
Top Products
564 SS / 564 E Rectangular Face
Black 95400411 Nickel 95400413
Page 6 of 6 7/19/07 © Travis Industries, Inc.
2 Place the face, face down, on a soft, non-scratching surface. Install the 564 Electric mounting brackets onto
the back of the face.
c
b
a
Remove and
discard the
hinge assembly
from the face.
d
Attach the lower 564 E bracket (and
shim). Use the nuts removed earlier and
one of the nuts included with this kit.
Attach the upper 564 E
bracket (and shim). Use the
nuts included with this kit.
Repeat steps “a” through
“c” for the opposite side.
e
Before installing the
face verify the lower
grill is centered.
Loosen the nuts and
adjust if necessary.
3 Pull the electric fireplace out of the mantel (or built-in location). Attach the cove covers and face following the
directions below. Slide the fireplace back into place to complete the installation.
Tilt the face back slightly and
insert the bottom hooks into
the slots on the fireplace.
Lift the face up slightly, tilt
it forward and insert the
top hooks until the face
locks in place.
b
a