Filter
Top Products
564 E Matrix Face
95400488
Page 2 of 2 9/18/07 © Travis Industries, Inc.
Installation
NOTE: We recommend pulling the fireplace out a couple of inches while installing or removing the face to
insure the hooks on the face fully engage the slots on the fireplace.
1 Install the heat shield following the directions below.
Remove and discard the
stock upper heat shield.
Attach the heat shield included
with this kit (note position of the
shield).
2 Attach the face following the directions below.
Tilt the face back slightly and insert the
bottom hooks into the slots on the fireplace.
Lift the face up slightly, tilt
it forward and insert the
top hooks until the face
locks in place.
b
a