Filter
Top Products
x 10
1/4-20 x 14mm
SCREWS
HARDWARE USED:
Assembling and Mounting the Fan Blades
9
Installing the Switch Cup Assembly
1. Securely attach the 9-pin connector from motor
assembly to wiring harness socket within switch cup
assembly.(Figure 17)
x 15
x 15
FIBER WASHER
3/16-24 x 10 mm
WASHER HEAD
SCREWS
HARDWARE USED:
Figure 16
Figure 17
Blade
Blade Holder
Figure 15
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm.
With a phillips screwdriver, tighten 3/16-24 x 10 mm
washer head screws and fiber washers to secure the
blade to the blade arm. (Figure 15)
2. Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws throught the holes
located on the side of the motor support. (Figure 16)