Filter
Top Products
7
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
1. Connect the green grounding lead from the hanger ball
and the green grounding lead from the hanger bracket to
the supply grounding conductor (this may be a bare wire
or wire with green colored insulation). Securely connect
wires with wire connectors supplied.
2. Securely connect the white fan motor wire to the white
supply (neutral) wire using wire connector supplied.
Securely connect the black fan motor wire and blue wire
to the black supply wire using wire connector supplied
(Figure 1). After connections have been made, turn leads
upward and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet box
and the black and blue leads on the other side of the outlet
box.
3. Proceed to the next step of “Installing the Canopy
Housing“.
Household
Supply
Listed
Outlet Box
Black
Green Wire
(Ground) from
Hanger Bracket
Green Wire
(Ground)
Black
Fan Wire
White
Blue
Green Wire
(Ground) from
Hanger Bowl
Figure 1
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
▲
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
Installing the Canopy Housing
Figure 1a Figure 1b
NOTE: This step is applicable after the necessary wiring
is completed.
▲
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Loosen the two shoulder screws in the Hanger
Bracket.
2. Securely attach the Canopy Housing over the shoulder
screws (Figure 1a).
3. Securely attach and tighten the Canopy Screw Cover
over the shoulder screws in the Hanger Bracket utilizing
the keyslot twist-lock feature (Figure 1b).