Faber SILENCE Indoor Fireplace User Manual


 
UK/IRL
25
UK/IRL
24
4.5 Fitting the firebox (continuing)
8. Spread, the bags of embers (imitation ashes) provide with the
appliance over the burner tray.
Attention! No embers on the grid end between the logs and the
burner tray.
9. Before placing the glass; check the glass sealing rope is in good
condition and makes an effective seal. Be sure that there are no
fingerprints on the glass. It is not possible to remove those prints
after you burn the appliance for a while (they are burnt in).
- Widescreen and Whisper; Place the glass in front of the appliance
and fix it with the glass clamps. Replace the frame.
- Misty, Cadra Nova and Spectra Nova:
Place the door and fix it. Check on visual leakages around the
door sealing.
10. Misty and widescreen: Fix the back and top or door frame (the back
frame first).
ceramic blanket
ceramic
blanket
ceramic
blanket
ceramic
blanket
ceramic
blanket
4.5 Fitting the firebox
Points of attention for placement:
- If possible, first locate the appliance before assembling the flue.
- If this is not possible then always use an extendible pipe before
connection onto the appliance.
1. Position the firebox in the fireplace opening. You can adjust the
height with the 4 adjustable feet.
2 Make the gas connection according to the instructions (also see gas
connection, chapter 4.1).
3. Assemble the flue system onto the firebox (see chapter 5).
4. Check if applicable that the safety hatch seals the combustion
chamber properly.
5. If necessary, place the DC convection system (also consult the
instruction belonging to the DC construction set).
6. Isolate the firebox with a ceramic blanket (25 mm). Preferred choice
for insulation is unbound insulation wool (at 1000 °C gives no
smell).
7. Place the log set (see placing log set, chapter 4.4).
safety hatch
fig. 16
fig. 17