Filter
Top Products
4. For stubborn stains and to
maintain a bright,
intensive beam of light,
use a damp cloth with
mild soap and water
to clean the transparent
bulb cover.
90-DAY LIMITED
WARRANTY
E
XCALIBUR ELECTRON-
ICS, INC., warrants to the original
consumer that its products are free
from any electrical or mechanical
defects for a period of 90 DAYS
from the date of purchase. If any
such defect is discovered within
the warranty period, EXCALI-
BUR ELECTRONICS, INC.,
will repair or replace the unit
free of charge upon receipt of
the unit, shipped postage prepaid
and insured to the factory address
shown below.
The warranty covers normal
consumer use and does not cover
damage that occurs in shipment
or failure that results from altera-
tions, accident, misuse, abuse,
neglect, wear and tear, inadequate
maintenance, commercial use,
or unreasonable use of the unit.
NIGHTLIGHT
INDICATOR
SWIVEL HANDLE
AC P
lug
Operating your Flashlight
Using Mode Select :
•
Click the mode select
switch
once to make use
of a single LED. This
is useful to spotlight an area
but donʼt want or need to
use the maximum amount
of light.
•
Click the mode select
switch one more time to
activate all 3 LED lights,
giving you the maximum
amount of light and
illumination.
To charge using an AC outlet:
1. Turn the swivel handle 90
degrees in order to
expose the polarized plug.
2. Rotate the plug 90 degrees
and insert directly into an
standard 120V AC outlet.
3. Fully charge the unit
for 24 hours.
4. Once fully charged, the
fl ashlight will last
approximately 80 minutes
using the single LED
light or 40 minutes using the
triple LED lights.
5. When left plugged into the
AC outlet with the ON/OFF
switch set to the ON position,
the fl ashlight will turn on
automatically when there is a
power outage.
6. The red nightlight will
automatically turn on when
the unit is plugged in.
To charge using the EZ Crank
handle:
1.
Lift the EZ Crank handle and
turn clockwise.
2. Fully charge your fl ashlight
by turning the EZ Crank
for approximately one hour
at a speed of 120 revolutions
per minute.
3. Once fully charged, the fl ash
light will last approximately
80 minutes using single LED
light or 40 minutes using the
triple LED lights
.
Replacing the Ni-MH
Rechargeable Battery
1. Using a fl at head screw
driver, remove the battery
cover.
2. Disconnect the battery and
replace with a new Ni-MH
3.6V 80mAh battery.
3. Replace the battery cover.
Special Care and Handling:
1. Avoid excessive humidity,
moisture, and extreme
temperatures. For
best results, store the unit
between the temperatures
of 14° F and 122° F (-10°C
and 50° C).
2. Do not immerse the unit in
water.
3. Clean using only a damp
cloth. Do not use any
chemicals or solvents.