Filter
Top Products
12 13
Special Care & Handling
• Always turn off the flashlight when charging.
• Do not charge for more than 24 hours straight. This
could damage the unit’s recharging system.
• Avoid rough handling such as bumping or dropping.
• Avoid extreme temperatures. For best results, use
between the temperatures of 39º F and 100º F
(4º C and 38º C).
• Clean only using a slightly damp cloth. Do not use
cleaners with chemical agents.
• Do not expose your Forever Flashlight EZ Crank
Extreme to direct sunlight or other heat source
for any length of time.
• Clean the lens with glass-cleaning products.
• Do not use petroleum distillates (such as gasoline or
kerosene) or solvents such as acetone to clean
any part of the Forever Flashlight EZ Crank Extreme.
** This product uses rechargable batteries for energy
storage that may eventually need to be replaced after
extended use.
This device complies with Part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable l interference in a residential
installation. This equipment generates, uses and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Excalibur Electronics reserves the right to make
technical changes without notice in the
interest of progress.