Filter
Top Products
1-8
1.3.2. EPTZ3000/EPTZ3000I Base Board
The base board that is on the bottom of the housing connects to power cable, video cable,
control cable, alarm cable, fan and heater. In order to connect to cables, the board needs
to be taken off, and put back after finishing connecting to all cables. The connectors of
cable names are marked on the board in white text. The details of the alarm connector
(JP5) are shown on the APPENDIX A.
For EPTZ3000 outdoor model, JP1, JP3 and JP6 that are two-pin connectors need to be
taken off during installing. JP1 and JP3 are connectors for heater, and they can be
switched. JP6 is a fan controller connector that turns on/off of the fan. The 3 cables are too
short to be connected to a wrong connector when putting them back.
RELAY
JP6
JP4
JP3 JP1
JP5
Video +
Video -
RS485 +
RS485 -
AC24
AC24
EPTZ3000 Baseboard
RELAY
JP5
Video +
Video -
RS485 +
RS485 -
AC24
AC24
EPTZ3000I Baseboard