Filter
Top Products
3. Changing & Cleaning the Pre-Motor Filter:
A) This is best done every three months or depending on the amount
of usage.
B) Remove the front panel of the vacuum cleaner.
C) To remove the pre-motor filter, simply slide it out.
D) To clean the filter rinse in warm, soapy water. Filter must
by completely dry before re-installing into your vacuum.
E) Once filter has been replaced, replace front panel.
Assembling Your Vacuum Cleaner
Warning: Do not plug in vacuum unit until it is fully assembled.
1. Carefully unpack all components,
set aside packaging.
2. Lift vacuum body to upright position.
3. Remove the screws (2) that are already
attached to the body.
4. From the rear of the vacuum, align the handle
with groove and slide onto vacuum. If
necessary, use thumb and finger pressure
to slide handle into position.
5. Once handle is in place, attach the handle with
the screws (2).
4. Changing the Post Motor HEPA Filter:
A) This is best done once or twice a year depending on the amount
of usage.
B) Remove the HEPA Filter panel of the vacuum cleaner.
(See illustration below.)
C) To remove the post motor HEPA filter, simply pull it out.
D) Insert new post motor HEPA filter and replace HEPA Filter cover.
E) NEVER
operate the vacuum cleaner without the post motor
HEPA filter in place.
Operation
Please Note: If you are using the cloth bag, you should wash the
pre-motor filter in lukewarm water once or twice
a year. Make sure that the filter is completely dry
before you put it back into the vacuum cleaner.
Please Note:
The Cloth Bag is washable. It should however be replaced every three (3)
months to ensure peak performance of your vacuum.
5
NOTE: DO NOT OPERATE VACUUM WITHOUT FILTERS IN
PLACE.
2
1. Adjust the motorized power head for the
correct carpet height from low to high.
2. Plug power cord into electrical outlet.
3. Step on the handle release button to
release the handle.
(See illustration at right)
4. Press the On/Off button to the On position.
5. You are now ready to vacuum.
The lightweight upright vacuum can be used on multiple types of
carpeting, bare floors or upholstery with attachments. When using
the attachment tools such as the crevice nozzle or the dusting brush,
place the handle in the upright position.
How to Adjust for Carpet Height
WARNING: To avoid injury, keep loose clothing, hair, fingers and all
other parts of body away from any moving part (such as the beater
brush). Turn off the switch and unplug the vacuum before adjusting
the vacuum for the carpet height.
The front of the vacuum cleaner has a carpet adjustment knob that raises
and lowers the motorized power head to match the type of carpet. With the
vacuum NOT
connected to the electrical outlet, set the adjustment to the
lowest setting for maximum cleaning. If the vacuum is to difficult to push,
move the knob to the next highest setting until the vacuum is comfortable to
push. The beater brush must reach the carpet for effective cleaning.