Euro-Pro NP320 Vacuum Cleaner User Manual


  Open as PDF
of 16
 
11
www.sharkclean.com
Checking for Blockages
Blockages may cause your vacuum to overheat and
shut down. To prevent this from happening, check
potential blockage areas after heavy use or if you
detect a loss of suction or poor cleaning performance.
1 DUST CUP
Dust Cup may be full. Empty Dust Cup.
2 FILTERS (PRE-MOTOR AND POST MOTOR)
Ensure that both the Pre Motor Filters and the Post
Motor HEPA filter are clean.
3 ACCESSORIES
Check intake openings:
• PowerBrush
• CreviceTool
• UpholsteryBrush
• DustingBrush
• FlexibleHose
• FloorKitHandle
• StraightSuctionNozzle
CLEANING THE POWER BRUSH
•
Turn the Power Brush over, slide the locking latch
forward and tilt the cover upward to remove.
(fig. 15)
•
Inspect the rotating bristle brush, turbine wheel
and air passage.
•
Remove any blockage or debris and carefully,
without damaging the bristles or belt, cut any
build-up of hair or string wrapped around the
rotating bristle brush with scissors.
•
To reassemble, first insert the tabs on the front
edge of the cover into the matching holes in the
top half of the Power Brush and tilt the cover back
down pressing until it clicks into place. (fig. 16)
Locking
Latch
Rotating
Bristle Brush
Turbine
Wheel
Fig. 15
Fig. 16
NP320series_40_IB_ENG_120409_2.indd 11 12-04-09 2:08 PM
 previous next