Filter
Top Products
USAGE SUGGESTIONS FOR STEAM CLEANER GETTING TO KNOW YOUR STEAM CLEANER
1. Power On Light (Red)
2. Ready Light (Green)
3. Handle
4. Flexible Hose
5. Hand Grip
6. Steam Trigger
7. Safety Filler Cap
8. Concentrator
9. Floor Brush
10. Extension Tubes (x2)
11. Window Squeegee
12. Detail Brush (x2)
13. Shoulder Strap
14. Funnel
15. Power Cord
16. Trigger Lock
Window, Glass Surfaces and Mirrors
Use the dual edge glass and tile squeegee.
Work with the vapor jet on using the top to
bottom movements. Use the squeegee
with the vapor off to clear the water from
the glass. To do this without leaving
streaks, use lateral movements from the
top to the bottom of the surface.
Garden Furniture
Use any of the brushes depending on the
surface area. Work quickly when cleaning
resin outdoor furniture. Finish by wiping
with a towel
Blinds
Use the detail brush to clean blinds.
Move the brush over the surface, allowing
enough time for the vapor to penetrate.
Work quickly on PVC blinds. Test for
color fastness on fabric blinds before
using. Finish by wiping with a towel.
Fiberglass or Stainless Steel Surfaces
Use the floor brush or detail brush. Slowly
move the brush over the surface to be
cleaned. The vapor will emulsify the dirt
and grease on the surface. Follow behind
with a terry cloth towel over the brush to
remove excess moisture and residue.
Tip: An old idea for polishing stainless
steel is to wipe it down with seltzer soda
water after it is cleaned.
Bathroom Areas
To clean the bathtub or shower area, use
the detail brush for grout, shower door
tracks, hard to get areas and heavily
soiled areas. The dual edge window/tile
squeegee will be the most efficient way to
clean the rest of the area. Allow plenty of
time for the heat to penetrate the surface.
This is especially helpful in the shower
area if there is tile or grout. Wipe with
towel.
Removal of soap scum on tile, grout, and
shower doors is also easier with the
steam cleaner.
To clean sanitary fixtures, use the
concentrator with or without detail brush.
Use a terry cloth towel or paper towel to
wipe up excess moisture and residue.
To clean the sink and faucets, use detail
brush then finish by wiping with a towel.
Soap Scum
Soap scum dissolves almost immediately
under a combination of heat and moisture.
Rinse the surface with a small amount of
water afterwards or go back over it once
more with a clean terry cloth towel.
Note: Soap scum sometimes will develop a
hard surface from waterborne minerals. If
this is the case, use the floor brush with no
towel first to break up this surface - or
spray or wipe first with lemon, vinegar or
seltzer soda water to soften the minerals.
Moving too slowly can dry out the soap
scum and cause it to granulate on the
surface. The surface will have a gritty feel.
If this happens, apply vapor to the surface
with the open brush again and re-clean.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 1550 Watts
Water Capacity: 40 US Fl. Oz. (1200 ml.)
Steam Generator: Stainless Steel
10
3