Filter
Top Products
OPERATING INSTRUCTIONS cont.
PRECAUTIONARY MEASURES
4. Take the HEPA dust cup filter out of
the dust cup, do not let the dust fall
out.
5. Take out the dust cup and dispose of
the dust inside.
HEPA Dust
Cup Filter
Dust Cup
Cleaning & Changing the
HEPA Dust Cup Filter (cont.)
Important: If the suction opening in the unit, the hose or the extension tube are
BLOCKED
, switch off the vacuum cleaner and remove the blocking substance before
you start the unit again.
9. Reassemble the debris screen to the
HEPA filter cartridge and replace into
dust cup (container). Ensure that the
filter assembly is completely seated
inside the dust cup (container).
1. Do not operate the vacuum
cleaner to close to heaters,
radiators or cigarette butts.
4. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
10.Attach the dust cup (container) to the
vacuum.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
Fig. A
Warning: Allow 24
hours for drying before
replacing in unit.
PLEASE NOTE: The white pleated
filter material in the HEPA Dust Cup
Filter will discolor over time -This is
NORMAL and will NOT affect the
performance of the filter. If the HEPA
Dust Cup Filter
is properly
"TapCleaned”
after each use
and suction
does not return
to 100%, then
we suggest that
the HEPA filter
be “TapCleaned”
vigorously until no
more dust can be removed, then
rinsed under the faucet and allowed to
dry for 24 hours before refitting into
the vacuum. (Fig. A) Wash once
a month or when suction appears
reduced.
Wash once
a month or
when
suction
appears
reduced.
6. Do not use without dust cup filter or
filters in place.
Note: This vacuum cleaner is equipped
with a plug and power cord that retract
automatically. If the cord or plug get
damaged, it must be replaced by a
qualified technician.
HEPA Filter Debris Screen
6. Separate the debris screen from the
HEPA filter cartridge by grasping the
debris screen with one hand and the
filter frame with the other and pull
apart.
3. Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the dust bag.
Warning: Hold the plug when
rewinding the cord. Do not allow the
cord to whip
when rewinding.
7. Vigorously
“TapClean” the HEPA
Dust Cup Filter on a
hard surface until no
more dust is observed
falling out from
between the pleats of
the filter.
CAUTION: The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
8. “TapClean” the Debris
Screen or rinse under
a faucet until clean.
Remember that
the Debris Screen
must be completely
dry before reinstalling
in the vacuum.
5
2