Filter
Top Products
9
HEPA FilterDebris Screen
11
7
8
12
10 13
OPERATING INSTRUCTIONS
GETTING TO KNOW YOUR BIG SHARK
Warning: Always unplug from
electrical outlet before opening the dust
cup (container).
Note: HEPA dust cup filter must be
used when operating the hand vacuum.
4. To use the flexible hose, push the
smaller end of the hose into the
suction hole, then attach the desired
accessory to the other end of the
flexible hose, as shown below.
Using The Unit As A Hand
Vacuum
2
Technical Specifications
Voltage: 115V~ 60Hz.
Power: 7.8 Amps, 900 Watts
8. Oval Brush
9. Holes for Attaching the Shoulder Strap
10. Dust Cup (Container)
11. Flexible Hose
12. Crevice Tool
13. Hepa Dust Cup Filter
1. Push to Open Dust Cup (Container)
2. On/Off Power Switch
3. Suction Hole
4. Handle
5. Exhaust Cover Lock
6. Exhaust Cover
7. Shoulder Strap
2. To use the Hand Vacuum with the
shoulder strap, attach it to the unit as
shown below.
1. To open the dust cup (container), push
button and pull out the dust cup. Verify
that the HEPA dust cup filter inside,
then attach the dust cup (container) to
the hand vacuum.
How To Operate Your
Hand Vacuum
1. Hold the hand vacuum firmly in
your hand by the Handle.
2. Push the On/Off Power Switch to
“On” position.
3. Start vacuuming.
CAUTION: The Hand Vacuum is a
very powerful unit. Make sure that you
hold it firmly, otherwise it can slip out of
your hand and cause injury.
3
3. To attach the crevice tool or oval
brush to the Hand Vacuum, push
brush into the suction hole, as
shown below.
Motor Thermostat
IMPORTANT: This motor is equipped with a motor protective thermostat.
If for some reason the vacuum cleaner should overheat,
the thermostat will automatically turn the unit OFF.
Should this occur, unplug the vacuum cleaner from wall
outlet or turn off switch. Allow the unit to cool. To restart,
re-plug into wall outlet or turn switch back on.