Euro-Pro 372 Sewing Machine User Manual


 
1
2
3
DRAWING UP THE BOBBIN THREAD
1.Hold the end of the needle thread with your left hand.
2.Turn the balance wheel slowly towards you with your right
hand until the needle goes down and comes up. Then stop
the balance wheel when the take-up lever is at its highest
position.
Lightly draw up the needle thread forming a loop with the
bobbin thread.
3.Puil about 15cm (6 inches) of both threads away from you
under the presser foot.
needle thread
needle
thread
bobbin
thread
-
zigzag foot
STRAIGHT STITCH AND ZIGZAG STITCH
Model 377 Model 374
Presser foot
Pattern selector
Stitch length dial
Model 373/372
zigzag foot
zigzag foot
M ( )
O ( )
A ( ) B ( )
or
or
(for straight gtitch)
(for straight stitch)
1 - 5 (54321) (for zigzag stitch)
0.3-4
0.3-4
C ( ) (for zigzag stitch)
( ) (for zigzag stitch)
( ) (for straight stitch)
Starting Sewing
1. Be sure both the threads are drawn back under the presser foot.
2. While holding the threads with your left hand, turn the balance
wheel toward you to bring the needle into the fabric where you
wish to start sewing.
3. Lower the presser foot, and press the speed controller gently,
then start sewing slowly.
*Sew a few reverse stitches by pushing reverse button for
reinforcing the end of seams.
*Raise the needle to its highest position before turning the
pattern selector dial and stitch width dial.
11
English