Euro-Pro 1104HP Sewing Machine User Manual


 
ACCESSORIES
Foot Pedal AC/DC Adapter
Bobbins (x2),
Thread Spools (x2), Needle,
Needle Threader
BATTERY INSTALLATION
1. Battery compartment is on the bottom of the
sewing machine.
2. Open the cover of the battery compartment and
insert the 4 “AA” alkaline batteries. Make sure
that the batteries are in the correct position as
marked on the inside of the battery compartment.
3. Replace the battery compartment cover.
Caution: Make sure that the On/Off Button is in the
“Off” position when inserting or changing the
batteries. If the On/Off button is in the “On” position
when inserting or changing the batteries, the sewing
machine may run suddenly.
THREADING UPPER THREAD
Caution: When threading the
sewing machine, make sure that
the On/Off button is in the “Off”
position.
1. Place the spool of thread into
the spool pin.
2. Thread the machine following
this sequence: , , , , ,
, , , k.
3
BOBBIN WINDING
8
To wind your bobbins:
1. Press on the bobbin winder lever to raise the bobbin winding pin.
2. Place an empty bobbin on the bobbin winding pin.
3. Place a spool of thread on the spool pin spindle.
4. Take the end of the thread from the thread spool and wind it counter clockwise
around the upper section of the thread clamper following the numbered sequence
in the illustration above.
5. Continue taking the thread around the needle bar.
6. Wrap the thread counter clockwise around the empty bobbin several times.
7. Press the bobbin winder button and run until the bobbin is full.
8. When the bobbin is full, release the bobbin winder button and remove the bobbin
from the bobbin winding pin.
9. Lift the bobbin winding lever to lower the bobbin winding pin.
Thread Clamper
Needle Bar