Filter
Top Products
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
1) Lower handle to floor and remove
HEPA filter.
2) Unscrew the lens and remove old bulb
(Fig. 7).
3) Replace with bulb rated 12v., 10w.,
Type 904. Push in new bulb, replace
lens cover and replace screw (Fig. 8).
4) Replace HEPA filter and return to
upright position.
Change Light Bulb
Make sure vacuum is turned off and power cord is unplugged.
1) Use handle release to lower handle
flat onto floor. Turn vacuum over on its
backside and remove 4 screws (Fig. 1).
2) Turn vacuum over to front side and
remove brush roll cover (Fig. 2).
3) Remove brush roll and belt (Fig. 3).
4) Thread new belt around motor shaft
and then the brush roll (Fig. 4).
5) Insert left end of brush roll first and
then the right end (Fig. 5).
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover (Fig. 2). Turn
vacuum over on its backside.
8) Replace screws
➌
&
➍
closest to
the brush roll first. Then replace
screws
➀
&
➁
(Fig 6).
!
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 1
➀
➂
➃
➀
➌
➍
➁
➁
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
Check EXT-U Belt. Replace if worn, cut or out of shape
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain Brush Roll
Motor can become hot with normal use.
Do not remove end caps. Remove hair and threads from brush roll periodically.