Filter
Top Products
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
1) Remove HEPA filter. See directions
on page 2 for removing the HEPA filter.
2) Unscrew the lens and remove old
bulb (Fig. 7).
3) Push in new bulb, replace lens cover and
replace screw back into place (Fig. 8).
4) Replace HEPA filter, filter door, foam
filter and frame and secure dust cup.
Change Light Bulb – Part number 57940-3
Make sure vacuum is turned off and power cord is unplugged.
1) Use handle release to lower handle
flat onto floor. Turn vacuum over on its
backside and remove 4 screws (Fig. 1).
2) Turn vacuum over to front side and
remove brush roll cover (Fig. 2).
3) Remove brush roll and belt (Fig. 3).
4) Thread new belt around motor shaft
and then the brush roll (Fig. 4).
5) Insert left end of brush roll first and
then the right end (Fig. 5).
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover (Fig. 2). Turn
vacuum over on its backside.
8) Replace screws
➌
&
➍
closest to
the brush roll first. Then replace
screws
➀
&
➁
(Fig 6).
Replace EXT-U Belt if Worn, Cut or Out of Shape – Part number 61120C
Motor can become hot with normal use.
!
!
!
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 1
➀
➂
➃
➀
➌
➍
➁
➁
Maintain Brush Roll – Call Eureka Customer Service HELPLINE – Part number 62365-4
Do not remove end caps. Remove hair and threads from brush roll periodically.