Filter
Top Products
Power-Touch
Hose Handle
How to Assemble and Use
POWER-TOUCH
®
Handle
Remote ON/OFF Selector for bare floor or carpet
*Off – push down on front
Bare Floor – push down on back
*Power ON/OFF for canister can only be controlled by canister ON/OFF
switch.
Vacuum Control
Cleaning suction is reduced by pushing lever to
LOW position. Place lever at HIGH position to
increase suction for carpet cleaning.
1. Snap interlocking wands together.
2. Push assembled wands into power nozzle.
3. Place Power-Touch hose handle into wands until plug connects and button
locks.
4. Insert hose coupling into top of canister and push hose power cord into
receptacle located on top of canister. The outlet has a protection side
cover which must be moved slightly towards the rear of the cleaner before
plug will go into the outlet. Make sure plug is fully seated in the outlet or
the motorized power nozzle may not function.
5. Pull on electrical cord and push plug into outlet. To rewind, step on
Cordaway cord reel button, hold and guide plug while it rewinds.
6. Step on handle release on the motorized nozzle to release handle; pull
back to comfortable work position.
7. Push On/Off canister switch.
(A thermostat automatically shuts off the motor if it overheats, see
Automatic Motor Shut-Off,)
8. Bare floor or carpet cleaning selection on remote control, only.
5
ON
Select bare floor or
carpet cleaning
Handle
Release
OFF
3
1
8
2
Quick Release
Foot Pedal (on
some models)
7
4
5
6