Filter
Top Products
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep,
and comb the carpet nap. The belt should be checked regularly to be sure it is in
good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away
any hair or thread wound around the brush roll or the belt pulley because the buildup
could cause the belt to rotate unevenly.
How To Replace A Worn Belt
NOTE: Turn off the switch and unplug the electrical cord before replacing
belt. Belt pulleys can become hot during normal use. To prevent burns,
avoid touching the belt pulley when servicing the drive belt.
IMPORTANT: Improper installation of the brush roll or brush roll belt could
cause carpet or cleaner damage.
1. Release cam locks.
Check for brush wear (see Brush Roll
instructions on page 10).
3. Place new belt around brush roll.
4. Align brush roll pulley with belt
guide.
7. Place lower side of belt into belt
guide and pull to stretch the belt
around the left side of motor pulley.
Rotate pulley to secure belt into
groove.
1
1
Motor
Pulley
2
2. Pull up on belt to rotate it off the
motor pulley. Lift up on brush roll
and remove worn belt.
Metal Brush Roll only.
Place rubber end cap covers
(available on select models) over both
end caps (flat side against end cap).
Align holes and secure.
5. Slant brush roll forward so end
caps are in line with slots in cleaner
base.
6. Push brush roll into base.
8. Place slots of bottom plate over
tabs of cleaner base.
9. Seat and secure cam locks.
Ask for GENUINE EUREKA
replacement belts, No. 52100
Look for the symbol.
GENUINE
EUREKA PRODUCT
Belt
Guide
7
6
5
8
8
9
9
9