Filter
Top Products
ENGLISH
When using an electrical appliance, basic precaustions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
Do not use outdoors or on wet surfaces.
Turn off the switch and unplug the electrical cord when not in use and before servicing.
Do not allow to be used as a toy. Close attention is necessary when used by or near children.
Use only as desribed in this manual. Use only manufacturer’s recommended attachments.
Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return
it to a service center before using.
Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep
cord away from heated surfaces.
Hold plug when rewinding onto cord reel. Do not allow plug to whip when rewinding.
Do not use extension cords or outlets with inadequate current carrying capacity.
Turn off all controls before unplugging.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not handle plug or vacuum cleaner with wet hands or operate without shoes.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airow.
This vacuum cleaner creates suction. Keep hair, loose clothing, ngers, and all parts of body away from openings and moving parts.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Do not use without dust cup or lter(s) in place.
Use extra care when cleaning on stairs.
Do not use to pick up ammable or combustible liquids such as gasoline, or use in areas where they may be present.
Store your cleaner indoors in a cool, dry area.
Keep your work area well lighted.
Unplug electrical appliances before vacuuming them.
Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
this appliance has a polarized plug (one blade is wider then the other). This plug will t in a polarized outlet only one
way. If the plug does not fully t into the outlet, reverse the plug. If it still does not t, contact a qualied electrician to install the proper outlet. Do NOT change
the plug in any way.
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly shuts off, push the on/off switch off
(0) and unplug the cleaner. Check the cleaner for a possible source of overheating such as a full dust cup, a blocked hose or clogged lter. If these conditions are
found, x them and wait at least 30 minutes before attempting to use the cleaner. After the 30 minute period, plug the cleaner back in and push the on/off switch
on (l). If the cleaner still does not run, then take it to a Eureka Authorized Service Center for repair.