DO NOT OIL the motor or the brush roll. The motor
and brush roll are permanently sealed and
lubricated.
To reduce the risk of fire, electric shock, or injury:
•
Do not use outdoors or on wet surfaces.
•
Do not leave vacuum cleaner when plugged in. Turn
off the switch and unplug the electrical cord when not in
use and before servicing.
•
Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
•
Use only as described in this manual. Use only
manufacturer’s recommended attachments.
•
Do not use with damaged cord or plug. If vacuum cleaner
is not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return it to a service
center before using.
•
Do not pull or carry by cord, use cord as a handle, close
a door on cord, or pull cord around sharp edges or
corners. Do not run vacuum cleaner over cord. Keep cord
away from heated surfaces.
•
Do not use extension cords or outlets with inadequate
current carrying capacity.
•
Turn off all controls before unplugging.
•
Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
•
Do not handle plug or vacuum cleaner with wet hands.
•
Do not put any object into openings. Do not use with any
opening blocked; keep free of dust, lint, hair, and anything
that may reduce airflow.
2
•
This vacuum cleaner creates suction and contains a
revolving brush roll. Keep hair, loose clothing, fingers, and
all parts of body away from openings and moving parts.
• Do not place cleaer on furniture or stairs as the brush roll
may cause damage. Pleace cleaner on floor with the
handle in storage position while using attachments.
•
Do not pick up anything that is burning or smoking, such
as cigarettes, matches, or hot ashes.
•
Do not use without dust cup or filter(s) in place.
•
Belt pulleys can become hot during normal use. To prevent
burns, avoid touching the belt pulley when servicing the
drive belt.
•
Use extra care when cleaning on stairs.
•
Do not use to pick up flammable or combustible liquids
such as gasoline, or use in areas where they may be
present.
•
Store your cleaner indoors in a cool, dry area.
•
Keep your work area well lighted.
•
Unplug electrical appliances before vacuuming them.
•
Unplug before connecting turbo nozzle, model 26.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a
polarized plug (one blade is wider than the other). This plug
will fit in a polarized outlet only one way. If the plug does not
fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do
not change the plug in any way.
GENERAL INFORMATION
Use the cleaner to pick up dirt and dust particles. Avoid
picking up hard or sharp objects that could damage the
vacuum cleaner.
Service Information
The instructions in this booklet serve as a guide to routine
maintenance. For additional service information, telephone
our toll free number for the nearest Eureka Authorized
Warranty Station. You should know the model, type and
serial number or date code when you call:
USA: 1-800-282-2886 Mexico: 5670-6169
Canada: 1-800-282-2886
.
If you prefer, you can write to The Eureka Company, Service
Division, 807 North Main St., Bloomington, Illinois 61701,
USA. In Canada, write to The Eureka Company, 866 Langs
Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka
Warranty for complete service information
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects
the cleaner in case of motor overheating. If the cleaner sud-
denly shuts off, push the on/off switch off (0) and unplug the
cleaner. Check the cleaner for a possible source of over-
heating such as a full dust cup, a blocked hose or clogged
filter. If these conditions are found, fix them and wait at least
30 minutes before attempting to use the cleaner. After the
30 minute period, plug the cleaner back in and push the on/
off switch on (l). If the cleaner still does not run, then take it
to a Eureka Authorized Service Center for repair.