Filter
Top Products
DO NOT OIL the motor or the brush roll. The
motor and brush roll are permanently sealed
and lubricated.
To reduce the risk of fire, electric shock, or injury:
•
Do not use outdoors or on wet surfaces.
•
Do not leave vacuum cleaner when plugged in. Turn off
the switch and unplug the electrical cord when not in use
and before servicing.
•
Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
•
Use only as described in this manual. Use only manufacturer’s
recommended attachments.
•
Do not use with damaged cord or plug. If vacuum cleaner
is not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return it to a service
center before using.
•
Do not pull or carry by cord, use cord as a handle, close a
door on cord, or pull cord around sharp edges or corners.
Do not run vacuum cleaner over cord. Keep cord away from
heated surfaces.
•
Do not use extension cords or outlets with inadequate
current carrying capacity.
•
Turn off all controls before unplugging.
•
Do not unplug by pulling on cord. To unplug, grasp the plug,
not the cord.
•
Do not handle plug or vacuum cleaner with wet hands.
2
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a
polarized plug (one blade is wider than the other). This plug
will fit in a polarized outlet only one way. If the plug does not
fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do
not change the plug in any way.
GENERAL INFORMATION
Use the cleaner to pick up dirt and dust particles. Avoid
picking up hard or sharp objects that could damage the
vacuum cleaner.
Service Information
The instructions in this booklet serve as a guide to routine
maintenance. For additional service information, telephone
our toll free number for the nearest Eureka Authorized
Warranty Station. You should know the model, type and
serial number or date code when you call:
USA: 1-800-282-2886 Mexico: (55) 5343-4384
Canada: 1-800-282-2886
If you prefer, you can write to Electrolux Home Care Products
North America, Consumer Service, P O Box 3900, Peoria,
Illinois, 61612, USA. In Canada, write to Electrolux Home
Care Products Canada, 866 Langs Drive, Cambridge, Ontario
N3H 2N7. Refer to The Eureka Warranty for complete service
information.
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects
the cleaner in case of motor overheating. If the cleaner sud-
denly shuts off, push the on/off switch off (0) and unplug the
cleaner. Check the cleaner for a possible source of overheat-
ing such as a full dust cup, a blocked hose or clogged filter.
If these conditions are found, fix them and wait at least 30
minutes before attempting to use the cleaner. After the 30
minute period, plug the cleaner back in and push the on/off
switch on (l). If the cleaner still does not run, then take it to a
Eureka Authorized Service Center for repair.
•
Do not put any object into openings. Do not use with any
opening blocked; keep free of dust, lint, hair, and anything
that may reduce airflow.
•
This vacuum cleaner creates suction and contains a
revolving brush roll. Keep hair, loose clothing, fingers, and
all parts of body away from openings and moving parts.
• Do not place cleaner on furniture or stairs as the brush roll
may cause damage. Place cleaner on floor with the handle
in storage position while using attachments.
•
Do not pick up anything that is burning or smoking, such
as cigarettes, matches, or hot ashes.
•
Do not use without dust cup or filter(s) in place.
•
Belt pulleys can become hot during normal use. To prevent
burns, avoid touching the belt pulley when servicing the
drive belt.
•
Use extra care when cleaning on stairs.
•
Do not use to pick up flammable or combustible liquids such
as gasoline, or use in areas where they may be present.
•
Store your cleaner indoors in a cool, dry area.
•
Keep your work area well lighted.
•
Unplug electrical appliances before vacuuming them.
•
Unplug before connecting turbo nozzle.