Filter
Top Products
HOW TO ASSEMBLE
Attach Handle
1. Locate the handle and body.
2. Line the handle up with the hole in the
top of the body. Flat side of handle and
loop forward.
3. Push handle down into body while
pressing button on back of the body.
Handle will click into place.
4. There are two handle positions available.
Handle all the way up and handle all the
way down.
5. Button needs to be depressed to raise
and lower the handle.
Insert Battery
Hold battery so thumb is positioned on thumb
grip button and push completely into body
until battery clicks into place.
Button
6
Loop
Handle
Body
Thumb Grip
Button
To Remove Battery
Grasp end of battery using thumb grip and pull
out of body.
NOTE: Charge the batteries for 14-16
hours before initial use. A cleaner
may lose charge in shipment. The
charger body will become warm,
however, this is not a cause for
concern.
NOTE: For extended battery run time and
to prevent long fringe of some area
rugs from wrapping around
brushroll, place switch in floors
(brushroll off) position.
NOTE: Cleaner will not run when charger
is connected and battery is in the
unit.
CAUTION: To avoid risk of fire, use only
genuine Eureka replacement
battery packs.
Thumb
Grip Button
Body
Battery