Filter
Top Products
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, make sure on/off switch is in
off (0) position before plugging in.
NOTE: Features may vary by model yet all parts
assemble the same.
HOW TO ASSEMBLE
Attach Handle
CAUTION: On models with looped handle, use special
care. Do not pinch electrical cord between
handle and cleaner.
1. From rear of cleaner, align handle with groove and slide
onto cleaner. If necessary, use thumb and finger
pressure to slide handle into position.
2. Attach handle with the two 1 inch screws provided in
the assembly packet. Use a Phillips
®
head screwdriver.
NOTE: Hand tighten with screwdriver to be sure both
screws are firmly seated.
3. Pick up hose and lay across upper hose retainer.
4. Push the end of the hose in the lower hose retainer to
secure.
4
Lower Hose Retainer
Hose
Upper Hose
Retainer
3
Attach Hose
Store Hose and Accessories
Nested Wands
Dusting
Brush
Store Electrical Cord
4
5. You will find your cord retainer on the handle above the
upper cord hook. Firmly push the electrical cord down
into the cord retainer. This will place the cord out of the
way the next time you vacuum.
6. Next wind the cord around the two cord hooks on the
back side of cleaner.
7. Secure the plug to the cord to prevent unwinding.
Cord Retainer
5
Cord Hook
6
Plug
7
Cord Hook6
Grooves
1
2
Electrical
Cord