Eureka 570 Vacuum Cleaner User Manual


 
HOW TO USE
Power Switch
The power switch has three positions. Off, Floor (hard surface cleaning) and Carpet.
Nozzle with Edge Kleener
®
Airflow under the nozzle automatically directs
suction to the edges and corners for maximum
full width cleaning.
Experiment with your hard floor surfaces,
sometimes it is best to have brush roll
turning. (Switch in the
carpet
position).
HOW TO MAINTAIN
The instructions given in this booklet serve as a guide to routine maintenance. Keep the
cleaner operating at top efficiency. Empty the dust cup after each use.
Empty Dust Cup
1. Pull dust cup latch
up.
2. Swing dust cup out
from body and up
off the dust cup
hook on the body.
4. To replace dust cup, fit
dust cup down onto
hook.
5. Swing down and push
gently into body until
dust cup clicks into
place.
3. Leaving dust cup filter in
the dust cup, shake
contents of dust cup into
a waste container. If
picking up lots of carpet
fuzz or pet hair, remove
filter. (To clean dust cup
filter refer to dust cup
filter section.)
Dual Uses
Push the handle button to release lock.
The handle will slide freely until it finds
one of the two available handle
positions. It automatically locks in either
of these two positions.
With the handle collapsed, the unit is
great for stairs and compact storage.
With the handle extended, the unit is
great for floor cleaning.
Power
Switch
Latch
Hook
7
Stair
Cleaning
Handle