Filter
Top Products
Clean
Under
Use
Handle
Release
3
7
HOW TO USE
The upright vacuum cleaner design allows use on multiple types of
carpeting and on upholstery or bare floors with attachments. When
using the attachment tools, place the handle in the upright
position. Do not place cleaner on furniture or steps as the brush
roll may cause damage.
1. Adjust cleaner height setting knob to lowest position for maximum
cleaning. Adjust to a higher setting to make pushing easier. For
easy adjustments, tilt the cleaner back to move the knob.
2. Plug electrical cord into outlet.
3. Step on handle release. Pull handle back to a comfortable position.
4. Push On/Off power switch.
Store or
Use Attachments
Handle
Release
ON/OFF
THERMAL CUT OFF
This cleaner has a special thermostat that protects the cleaner
in case of motor overheating. If the cleaner suddenly turns
off, follow this procedure:
1. Push on/off pedal once.
2. Unplug cleaner.
3. Check for source of overheating problem (i.e. full cyclonic dust
cup, clogged hose or clogged filter).
4. If a full cyclonic dust cup, clogged hose or clogged filter is
found, empty the cyclonic dust cup, unclog the hose or replace
the filters.
5. Wait at least 30 minutes before attempting to reuse the cleaner.
6. After 30 minute cool down period, plug the cleaner in and push
the switch pedal. The cleaner should turn on.
7. If the cleaner still does not operate, take it to any Eureka
Authorized Service Center for repair.
4
3
2
LOW
HIGH
1
Cleaner Height Setting
WARNING: Avoid injury. Keep loose clothing, hair,
fingers, and all other parts of body
away from any moving part (such as
the revolving brush). Turn off the
switch and unplug the cleaner before
changing the cleaner height setting.
The front of the cleaner has an adjustment that raises
or lowers the cleaner base to match the type of carpet.
With the cleaner cord unplugged, set the adjustment
to lowest setting for maximum cleaning. If the cleaner
is difficult to push, move adjustment to next highest
setting until cleaner is comfortable to push. The brush
roll must reach the carpet for effective cleaning.
NOTE: For ease in moving the adjustment knob,
place handle in operating position and tilt
cleaner back to remove weight from front
wheels.
NOTE: When handle is in upright position, brush
roll is lifted off carpet. This is normal. Height
adjustment will not change brush roll level
until the cleaner’s handle is moved into the
operating position.