Filter
Top Products
9
b
a
3
How To Empty Cyclonic Cassette
NOTE: Turn off the switch and unplug the electrical cord before emptying cyclonic cassette. Never operate the
vacuum cleaner without the cyclonic cassette or filters.
EUREKA RECOMMENDS EMPTYING THE CYCLONIC CASSETTE AFTER EACH USE AT A MINIMUM. DO NOT
OVERFILL.
Emptying the Cyclonic Cassette:
It is clearly visible when the dust compartment is full and needs emptying. Lift screen as shown (3) to completely empty
cyclonic cassette. It is possible to clean out the cyclonic cassette by using another vacuum.
CAUTION: The cyclonic cassette can be washed in warm water, if desired, but strong detergents should not be used. Dry
thoroughly before using again.
HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the
cyclonic cassette, belt, and brush roll often.
NOTE: The compartment with the screen (a) will fill much faster with larger dirt particles than
the compartment with the cone (b). This is normal. Empty the cyclonic cassette when
the side with the screen is full. Do not wait for the side with the cone to fill completely.
An over full cyclonic cassette will allow dirt to back up in the hose resulting in a clog.
It will also allow dirt to pass directly into the micron filter resulting in a drop in
performance. Therefore, empty the cyclonic cassette often.