Filter
Top Products
HOW TO ASSEMBLE
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, make sure on/off switch
is in off position before plugging in.
NOTE: Features may vary by model yet all parts
assemble the same.
Step A Attach Hose
(Refer to your hose adapter style)
To reduce the risk of electric shock, this appliance has a polarized plug (one blade wider than the other). This plug will t
in a polarized outlet only one way. If the plug does not t fully in the outlet, reverse the plug. If it still does not t, contact a
qualied electrician to install the proper outlet. Do not change the plug in any way.
GENERAL INFORMATION
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to prevent
bag tears, hose clogs, and fan blade breakage with subsequent motor damage.
Service Information
The instructions in this booklet serve as a guide to routine maintenance. For additional service information telephone our toll
free number for the nearest Eureka Authorized Warranty Station. You should know the model, type and serial numbers
when you call:
.USA: 1-800-282-2886
Mexico: 5670-6169
Canada: 1-800-282-2886
If you prefer, you can write to:
The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA.
In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3N 2N7.
Refer to The Eureka Limited Warranty for complete service information.
DO NOT OIL the motor or the brush roll at any time. The bearings are permanently lubricated and sealed.
3
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly
shuts off, push the switch pedal once and unplug the cleaner. Check the cleaner for a possible source of overheating such
as a full bag, a blocked hose or clogged lter. If these conditions are found, x them and wait at least 30 minutes before
attempting to use the cleaner. After the 30 minute period, plug the cleaner back in and turn on the switch. If the cleaner still
does not run, then take it to a Eureka Authorized Service Center for repair.
Tab
Hose
Adapter
1. Remove the front bag cover.
(Only required with Style B
adapter.)
2. Locate the tab on the hose
adapter of the extension hose
(shortest end). There are two
styles, either A or B. Each
style assembles identically.
3. Insert hose adapter into
opening on top of unit. The
hose adapter tab must be
placed all the way down
into the notch.
1
Style B
Style A
IMPORTANT:
Hose
MUST BE
inserted
before attaching
the handle.
Notch
3
2