Filter
Top Products
4
HOW TO ASSEMBLE (Continued)
Step B Attach Handle
CAUTION: Do not catch cord under handle.
4. From rear of cleaner, align handle with groove and slide
onto cleaner. If necessary, use thumb and nger pressure
to slide handle into position.
5. Once handle is in place, check that the hose adapter tab
is completely secure under the ledge of the handle.
6. Attach handle with two 5/8 inch screws in the assembly
packet. Use either a slotted or Phillips
®
head screwdriver.
7. Replace front cover.
Groove
Groove
Tab
Ledge
4
Step C Store Hose and Accessories
Combination
Tool
Crevice
Tool
Hook
Hose
Retainer
Tabs
Extension
Wand or
Wands
Carrying
Handle
HEPA Filter
(on some
models)
11. You will nd your cord retainer either at the bottom of
the upper cord hook or on the handle above the upper
cord hook. Firmly push the electrical cord down into
either cord retainer. This will place the cord out of the
way the next time you vacuum.
12. Next wind the cord around the two cord hooks on the left
side of cleaner. On some models the upper cord hook turns
to release the cord. Turn the hook up to store the cord.
NOTE: For easier access to bag compartment,
when you store the electrical cord use a
gure 8 pattern.
13. Secure the plug to the cord to prevent unwinding.
Hose
Adapter
10
Cord
Hook
Step E Store Electrical Cord
Paper Bag Collar
9
Cord
Hook
Cord
Retainer
11
11
12
12
Cord
Retainer
8
Step D Check Disposable Dust Bag
8. Remove front cover,
grasp both sides of
bag cover near top.
Push thumbs against
center of cover and
pull out on sides.
9. Check to be sure the
paper bag collar is
secure with the hose
adapter inside the
paper bag collar.
10. Replace front bag
cover.
5