Filter
Top Products
7
Fig. 2a
Fig. 2b
Handle
Tab &
Slot
Attaching the Cyclonic Bag
Saver onto the vacuum cleaner
Your vacuum cleaner is equipped with two
wands.
Fig. 2a Push the hose nozzle into the top of
the cyclonic housing until it is firmly
in place.
Fig. 2b Attach the cyclonic dust cup onto the
cyclonic housing. Place the slot in the
cyclonic dust cup over the tab on the
cyclonic housing. Then grasp the
handle on the cyclonic dust cup, and
pivot the cyclonic dust cup up and
over the ledge on the cyclonic
housing.
Fig. 3 Push the nozzle at the bottom of the
cyclone unit into the top of one of the
straight wands. Adjust the position of
the cyclone unit. Install the last
straight wand and then push the
assembled wands into the floor tool.
Important Safety Information
- Do not vacuum surfaces which have been
subjected to inflammable solvents.
- Do not pick up any liquid.
- Do not pick up hot ashes which could cause
a fire.
Emptying
Empty the dust compartment of the cassette
after each use or when the dust cup is filled
up to the MAX level, Fig. 3. Detach the dust
cup by following the instructions in Fig. 2b in
reverse.
Empty the contents into a waste container.
To reattach the dust cup again follow the
described steps in Fig. 2b.
Maintenance
The Cyclonic Bag Saver can be washed in
cold or warm water and a mild detergent.
Thoroughly dry the dust compartment with a
soft towel before using it again. If the cyclone
unit clogs, use the vacuum cleaner to unclog
it.
Cyclonic Bag Saver (on some models) continued
MAX
MAX
Fig. 3