Eureka 3280 Vacuum Cleaner User Manual


 
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
1) Lower handle to floor and remove
HEPA filter (Fig. 7).
2) Unscrew the lens and remove old bulb.
Replace with bulb rated 12 v., 10 w.,
Type 904.
3) Push in new bulb, replace lens cover
and replace screw (Fig. 8).
4) Replace HEPA filter and return to
upright position.
Change Light Bulb
Make sure vacuum is turned off and power cord is unplugged.
How to replace brush roll or belt
1) Use handle release to lower handle flat
onto floor (Fig. 1).
2) Remove 2 screws from brush roll cover.
(Fig. 2).
3) Lift off brush roll cover. (Fig. 3).
4) Remove brush roll and belt. Thread new
belt around motor shaft and brush roll
(Fig. 4).
5) Insert left end of brush roll first. Make
sure end cap fits into base (Fig. 5). Pull
right side of brush roll to stretch belt
and insert right end cap into base.
Make sure it slides into position.
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover (Fig. 3).
8) Replace 2 screws (Fig. 6).
!
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 1
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
Check EXT-U Belt. Replace if worn, cut or out of shape
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain Brush Roll
Motor can become hot with normal use.
Do not remove end caps. Remove hair and threads from brush roll periodically.