Filter
Top Products
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
1) Lower handle to floor and remove
HEPA filter (Fig 7).
2) Unscrew the lens and remove old bulb.
3) Push in new bulb, replace lens cover
and replace screw (Fig 8).
4) Replace HEPA filter and return to
upright position.
Change Light Bulb – Part number 57940-3
Make sure vacuum is turned off and power cord is unplugged.
1) Use handle release to lower handle
flat onto floor (Fig. 1).
2) Remove 2 screws from the front side of
brush roll cover (Fig. 2).
3) Lift and remove brush roll cover (Fig. 3).
4) Remove brush roll and belt. Thread
new belt around motor shaft and
brush roll (Fig. 4).
5) Insert left end of brush roll first. Make
sure square on brush roll cap is in
place. Pull right side of brush roll to
stretch belt. Secure right end cap into
base (Fig. 5).
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover (Fig. 2).
8) Replace 2 screws (Fig 6).
Check EXT-U Belt if Worn, Cut or Out of Shape – Part number 61120C
Avoid touching the motor shaft when checking brush roll belt.
!
!
!
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 1
Maintain Brush Roll – Call Eureka Customer Service HELPLINE – Part number 62365-4
Motor can become hot with normal use.
Do not remove end caps. Remove hair and threads from brush roll periodically.