Filter
Top Products
7
CONTROLS AND OPERATION
1. Plug cord into wall receptacle. Your humidifier is now ready for use.
2. The digital touch screen panel allows you to control the fan speed and humidity level
by simply tapping the appropriate up or down arrow switch on the front of the panel.
3. A digital display provides information on the status of the unit. Depending on which
function is being accessed, it displays ambient and set humidity, fan speed and
status of the unit.
FAN SPEED
4. Tap the up arrow or down arrow on the FAN SPEED section
to adjust the fan. The display will show F1 through F9
proceeding from low to high speed.
NOTE: When excessive condensation exists, a lower speed
setting is recommended.
HUMIDITY CONTROL
NOTE: Allow 10 to 15 minutes for the humidistat to adjust to the
room when setting up the unit for the first time.
NOTE: The DTS Series has an adjustable humidistat located
on the cord that measures the relative humidity in the room.
When the selected humidity level drops 3% below the relative humidity, the humidifier
cycles on and off as required to maintain the selected setting. At initial startup the
ambient humidity of the room will be displayed.
5. Tap the up or down arrow in the HUMIDITY SET section of the panel to adjust
the humidity level in 5% increments. At 65% set point, the unit will operate
continuously.
OTHER FEATURES / INDICATIONS
6. One bottle is designed to empty first. The control display a
flashing” F” when empty. When the unit is completely out of
water, the motor will shut off.
7. This humidifier has a check filter reminder timed to appear
after 720 hours of operation. When the Check Filter (CF)
message is displayed, disconnect the power cord and check
the condition of the filter. The CF function is reset after
plugging the unit back in.
FAN
SPEED
HUMIDITY
SET
Nighttime setting
Extinguishes all lights
Speed Control Humidity
Control
Reduce
Fan Speed
Increase
Fan Speed
Reduce
Humidity
Increase
Humidity
Power ON/OFF
Digital Display