Filter
Top Products
INSTALLATION OF LOG SET and EMBERS
INSTALLING THE GLOWING EMBERS
A bag of ceramic fiber embers is provided for use on the front burner ember tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the
ember material there may be more than required. Use only a single layer. Do not pile embers. The use of other
foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest
ENVIROGAS dealer for replacement embers.
Gently remove the ember material from the plastic bag. Spreading pieces evenly across the front and rear of the
ember tray.
Do not pack down, leave embers loose.
DO NOT PLACE EMBERS ON THE REAR BURNER.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOG SET
Carefully remove log from box. Check to ensure
there is no damage. It is very important to install this
log in its proper position to insure safe, optimum
operating conditions.
1. Open the front door.
2. Place the log set all the way into the back of
the firebox resting on the log supports.
3. Close the door and tighten securely.
Upon the first light up, watch for ignition to all burner
ports. If a long delay is noted:
a) First, wait for the appliance to cool down
b) Open the front door of the appliance.
c) Check to carefully reposition the embers making sure that
burner ports are not plugged solid or blocked.
(See adjusting the venturi section to adjust air for proper
flame).
8