Filter
Top Products
Operating Instructions
FOR YOUR SAFETY READ COMPLETELY BEFORE OPERATING.
LIGHTING INSTRUCTIONS:
6
CAUTION:
Hot while operating. Do not touch. Keep children, clothing,
furniture, gasoline or other flammable vapors away.
FOR YOUR SAFETY: Do not operate this fireplace with the glass removed, cracked or broken.
Replacement of this glass should be done by a licensed or qualified person! This appliance needs fresh
air for safe operation and must be installed with provisions for combustion and ventilation air.
See installation and operating instructions manual. Keep burner and control compartment clean .
Improper installation, adjustment, alteration, service or maintenance can cause property
damage, personal injury, or loss of life. Refer to owners manual. Installation and service must be
performed by qualified installer, service agency or the gas supplier.
WARNING:
TO TURN OFF GAS TO APPLIANCE
1.
2.
Flip burner switch to “OFF”
Turn the gascontrol knob clockwise to the “OFF”
position
3. Turn off all electrical power to the applianceif service isto
be performed.
ACLIE-1
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: IF YOU DO NOTFOLLOW THESE INSTRUCTIONS EXACTLY,AFIREOR EXPLOSIONMAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A)
B) BEFORE LIGHTING
WHATTO DOIF YOU SMELLGAS:
Thisapplianceis equippedwith a pilot, whichmustbe litby
hand
smell all around the appliance area
for gas
Do not try tolight any appliance. Do not touch any electrical
switch:
Immediatelycall your gas supplier from a neighbors phone.
Follow
by following these instructions exactly.
and next to the floor because some gas is heavier
than air and will settle on the floor.
donot use any phone in yourbuilding.
the gas suppliersinstructions.
If you cannot reach yourgas supplier, call the firedepartment.
Use onlyyourhand topushin orturn the gascontrol knob,
Call a qualified service technician. Force or
Donot use thisappliance if any part hasbeenunder water.
C)
D)
Never use tools. If the knob will not push in or turnby
hand,donot try to repair it.
attempted
repair may result in afire or explosion.
Immediately call a qualifiedservice technician to inspect
the appliance and toreplace any part of the controlsystem
and anygas controlwhichhas been under water.
LIGHTING INSTRUCTIONS
1.
2.
3.
4.
5.
STOP!Readthe safety information above on this label.
Turn off all electrical power to this appliance.
Turn off the gas control knob clockwise to the off
position.
Open door. Wait five (5) minutes to clear outany gas.
Close door.
If youdo not smell gas goto the next step
Find pilot-located tothe rightbehind the side log.Turn
the gascontrol
If you smell gas, including near the floor ,
STOP!Follow“B” inthe above safetyinformation.
knob counter-clockwise to “PILOT”.
Push the gas control in
fully and hold, Keep knob
depressed for about 30 secondsafter
pilotislit. Release knob. If pilotgoes out,
repeatsteps4 through 5.
: this gasvalve hasa lockoutdevice, whichwill
not allow
stop and immediately
If thepilotdoes notstaylit after several tries,turn the gas
control
Turnthe gas controlknob counter clockwise to the
“ON”
Turnon the electrical power to the unit.
WARNING
6.
7.
the pilot burner to be relit untilthe thermocouple
has cooled. Ifthe knob does not pop upwhen released,
call your service technician or gas
supplier.
knob to “OFF” andcall your service technician or
gas supplier.
position.Flip the burner switch to
“ON” THEN TURNTHE“HI/LOW” knobtothe desired setting.
Figure 2. Lighting instruction label.