Filter
Top Products
Installation
DOOR INSTALLATION:
Please inspect all components for damage. If damage has occurred, please contact the courier company,
dealer, or distributor and have components repaired or replaced before installation. Remove the door
from the packaging. Inspect the door assembly for damage.
1. Install door handle as shown in Figure 50.
Close the door
assembly and
turn the door
handle
downwards
until door is
tight.
Thread slider
damper handle
onto slider damper
control on the side
of the unit.
Nut
Cast Latch
Washer (x2)
Spring Washer
Furel
Handle
4. Place a hinge cap on each of the
pins. WARNING: The hinge caps are
removable, therefore please keep
out of the reach of children under 3
5. Please clean all ngerprints off of
all plated surfaces, with denatured
alcohol on a soft cloth, before ring
the unit each time. Fingerprints, etc.,
can become permanently etched
into the plating if not removed
before operating the stove.
NOTE: When the door is installed on
the unit and the handle closed, ensure
that the spring handle is at the 4:00
position.
2. Place the door assembly on the two (2) hinge pins
mounted on the body of the unit. Refer to Figure 51.
3. Open and close the door, applying pressure down, to
ensure the door assembly is properly seated on the
hinges. Refer to Figure 52.
Figure 51: Installation Door onto Unit.
Figure 50: Installation Door Handle
Hardware.
Figure 52: Closing Door.
DO NOT USE DOOR IF GLASS IS BROKEN.
42