Filter
Top Products
35
Installation
DOOR INSTALLATION:
Please inspect all components for damage. If damage has occurred, please contact the courier company,
dealer, or distributor and have components repaired or replaced before installation. Remove the door
from the packaging. Inspect the door assembly for damage.
1. Install door handle as shown in Figure 42.
Close the door
assembly and
turn the door
handle
downwards
until door is
tight.
Thread slider
damper handle
onto slider damper
control on the side
of the unit.
Nut
Cast Latch
Washer (x2)
Spring Washer
Furel
Handle
4. Please clean all ngerprints off of
all plated surfaces, with denatured
alcohol on a soft cloth, before ring
the unit each time. Fingerprints,
etc., can become permanently
etched into the plating if not
removed before operating the
stove.
NOTE: When the door is installed
on the unit and the handle closed,
ensure that the spring handle is at
the 4:00 position.
2. Place the door assembly on the two (2) hinge pins
mounted on the body of the unit. Refer to Figure 43.
3. Open and close the door, applying pressure down, to
ensure the door assembly is properly seated on the
hinges. Refer to Figure 44.
Figure 43: Installation Door onto Unit.
Figure 42: Installation Door Handle
Hardware.
Figure 44: Closing Door.
DO NOT USE DOOR IF GLASS IS BROKEN.