Filter
Top Products
SECTION IV: ACCESSORY ITEMS
AC-104 (SH-104) Brass Trim
The AC-104 trim kit covers the two front edges of the stove and the three edges of
the cover plate. The stove lip trim simply snaps over the edges of the stove. There are
two angle clips that hold the three pieces of cover plate trim together – connect the three
edges together and slide from the top down over the cover plate edges. The top piece of
trim must be forced out slightly so it will connect with the top edge of the plate.
AC-01 Brass Knobs
These decorative knobs have a wide base and rest on the top of the stove.
AC-02 Brass Rail
This decorative accessory rests on top of the stove.
SECTION V: OPERATING INSTRUCTIONS
A. Building a Fire
Your stove is equipped with a catalytic combustor, which requires a specific start up
procedure. Inspect your unit to be sure the combustor is seated properly in the
combustor collar.
CAUTION: ALWAYS OPEN (PULL OUT) THE BY-PASS DAMPER BEFORE
STARTING A FIRE OR RELOADING YOUR STOVE. NEVER USE KEROSENE,
GASOLINE, DIESEL FUEL OR CHARCOAL LIGHTER FLUID TO START OR RE-
KINDLE A FIRE.
Notice: Your new unit and the connector pipe will smoke with the initial fire. This is
called “cooking out” and is no cause for alarm, but it is a good idea to open windows and
doors in your dwelling during the first two hours of operating a new stove.
1. Be sure there are no combustibles in the immediate area of the stove.
2. Open the slide damper above the door (slide to left) and pull the by-pass damper all
the way out.
3. Place several pieces of crushed newspaper evenly over the bottom of the stove.
4. Place small dry sticks of kindling on top of the paper.
5. After igniting the paper, leave the door cracked slightly.
6. Once the kindling is burning freely, you can add several pieces of dry split wood to
the fire. Continue to leave the door cracked slightly.
7. When the split wood starts to turn to charcoal, the firebox can be filled with seasoned
wood. Allow this wood to burn (with the door cracked) for another ten to fifteen (10 to
15) minutes.
8. Close the door completely, leaving the draft controls in the open position. Push in the
by-pass damper handle after about five (5) minutes.